This is the model generator for Ostat hose and pipe adapter .
Any changes you make are saved in the URL, so you can share that URL or create a bookmark to keep those changes around.
README .vacuum-hose-adapter-basic ,
vacuum-hose-adapter ,
funnels
End1_ Wall_ Thickness
Wall thickness
End1_ Measurement
Is the measurement the adapter's outside or inside diameter?
End1_ Diameter
End 1 diameter of the adapter (mm, inch)
End1_ Length
Length of the start connector, including the flange (mm, inch).
End1_ Taper
Taper of the start connector, use negative to taper other direction.
End1_ StopThickness
Thickness of hose stop
End1_ StopLength
Length of hose stop
End1_ Stop_ Symmetrical
Should the stop be tapered both sides. Might easier to print.
End1_ Barbs_ Count
Number of barbs
End1_ Barbs_ Thickness
Thickness of the barbs, default is half wall thickness
End1_ Barbs_ Symmetrical
Should the barbs be tapered both sides. Might be easier to print.
Transition_ Style
tapered for hose connections, flat for attaching to a device
Transition_ Length
Length of the transition between the two ends
Transition_ Bend_ Radius
Radius of transition bend (mm)
Transition_ Angle
Angle of bend through the transition section.
End2_ Wall_ Thickness
Wall thickness
End2_ Measurement
Is the measurement the adapter's outside or inside diameter?
End2_ Diameter
End 2 diameter of the adapter (mm, inch)
End2_ Length
Length of the start connector, including the flange (mm, inch).
End2_ Taper
Taper of the start connector, use negative to taper other direction.
End2_ StopThickness
Thickness of hose stop
End2_ StopLength
Length of hose stop
End2_ Stop_ Symmetrical
Should the stop be tapered both sides. Might easier to print.
End2_ Barbs_ Count
Number of barbs
End2_ Barbs_ Thickness
Thickness of the barbs, default is half wall thickness
End2_ Barbs_ Symmetrical
Should the barbs be tapered both sides. Might be easier to print.
Enable_ Debug_ Slice
Slice model in half to be able to easy see inside
Enable_ Calipers_ Slice
Will only show if debug is also enabled
Enable_ Help
fa
minimum angle for a fragment (fragments = 360/fa). Low is more fragments
fs
minimum size of a fragment. Low is more fragments
fn
number of fragments, overrides $fa and $fs